Landee Pipe Fitting is committed to manufacturing of Piping Bend, Cap, Coupling, Elbow, Reducer, Stub End, Tee, Olet, Joint, Gasket, etc. Our mission is to improve the flow control ability of oil, gas, water, steam, acid liquid and other fluid.
Product Name: Stainless Steel 90 Degree Elbows Type: 90 Degree Elbow, Long Radius Design Standard: ASME B16.9 Material: ASTM A403 WP304, Stainless Steel Size: 2 Inch, DN50 Wall Thickness: SCH 10 End Connection:...
Abstract: This study investigates pipe perforation and leakage caused by erosion from ammonium chloride crystallization in the top circulation system of heavy-oil catalytic cracking units. By...
Product Name: ASTM A403 WP304 Stub End Design Standard: ASME B16.9, MSS SP-43 Material: ASME SA403 WP304, ASTM A403 WP304 Size: 1 Inch, DN25 Wall Thickness: SCH 10 Surface Finish: Shot Blasting
Abstract: This study investigates the formation of the σ phase in austenitic heat-resistant steel pipe joints used in power plant boilers. Results show that different morphologies of the...
Product Name: Full Thread Stud with Nuts Type: Full Thread Stud with Nuts Design Standard: ASME B18.2.1 Bolt Material: ASTM A193 Grade B7 Nut Material: ASTM A194 Grade 2H Size: 7/8 Inch Length: 4-1/2...
Abstract: During a scheduled inspection at a petrochemical plant, pitting corrosion was detected in the base material of a TP304 ethylene pipeline elbow. To determine the cause and develop effective...
Product Name: ASME B18.2.1 Stud & Nuts, Full Thread Design Standard: ASME B18.2.1 Bolt Material: ASTM A193 Grade B7 Nut Material: ASTM A194 Grade 2H Size: 1-1/8 Inch Length: 7-1/4 Inch (End to End)...
Abstract In a thermal power plant project, small-diameter serpentine heat exchanger tubes were fabricated from 20G steel with dimensions of Ø25 × 3 mm, a bend angle of 180°, and a bend...
Product Name: Phenolic Insulation Kit, Type F Flange Insulation Kit Material: Phenolic Size: 12 Inch, DN300 Pressure Rating: Class 300 LB, PN50 Components: Gasket, Sleeves, Washers
Abstract: A numerical simulation study of pipe cap hot forming was conducted using DEFORM-3D finite element analysis software to determine the optimal heating temperature and dimensions of the pipe...
